XGPC v1.3 New Feature
This section provides information that has been added to the new release of XGPC. This includes the following:
- Change a Communication Driver in XGPC.
- Change a Project Tree in XGPC.
- Support the X8-M Series A FRN4.
- Additional Inline Indirect Address Translation feature.
- f option in BCC for the communication with CSD5 Servo Driver
- CRC.7
- CRC.8ct
- CRC.8mx for the communication with Autonics MP5 Series
- CRC.16dnp3
- Add MSG Done ACK bit.
- Added SR2.3.3, Always OFF Bit.
- Added Modbus Consecutive Memory Address feature for Modbus Extended Holding register
- Add Change IP to Static feature
- Added counters for ASCII/Binary driver.
- Add Socket MSG Diagnostic Info.
- Changed default Ethernet MSG Connection Timeout from 1500 to 300 in msecs
- Show Number Of Expansion I/O Attached in SR2.92
This section provides information on issues that have been resolved with the latest release of XGPC. This includes the following:
- Corrected lbl & jmp instruction err in OLE
- Fixed offline operation when XGPC reading CS0 or PTO0
- Corrected 32bit configuration of MSG instruction
- Save CS and ES Data tables in online save.
- Corrected 28h System Fault while Indirect Addressing is used with large Data Table memory.(X8-M Series A FRN 4)
- Ethernet port may be locked up while large Ping packets are received.(X8-M Series A FRN 3)
- Added to check Read or Write data table in a Socket MSG instruction. This may cause 5h fault according to XGPC software.(X8-M Series A FRN 3)
- Corrected Modbus TCP data validation while insufficient data is received. Received packet with insufficient data is discarded.(X8-M Series A FRN 3)
- Corrected User Watchdog Fault by MSG instruction while OLE.(X8-M Series A FRN 3)
- Corrected Ethernet receive or transmit buffer underrun.(X8-M Series A FRN 3)
- Corrected Missing packet in Ethernet packet receiver.(X8-M Series A FRN 3)
- Corrected timing accuracy of timer for the Serial drivers.(X8-M Series A FRN 3)
- Corrected INV instruction within MCR zone.(X8-M Series A FRN 3)
- Corrected SR2.71, Program ID for Memory Card.(X8-M Series A FRN 3)
- Corrected Ethernet receive or transmit buffer underrun. This issue was caused by the Socket MSG.(X8-M Series A FRN 3)
- Corrected TCP sequence number handling issue.(X8-M Series A FRN 3)
- Corrected missed transmit packets over Ethernet.(X8-M Series A FRN 3)
- Corrected Socket MSG connection handling on extremely high network traffic.(X8-M Series A FRN 3)
- Fixed Connection completed counter in Socket MSG.(X8-M Series A FRN 3)
- Fixed the bit configuration in Modbus Slave Serial driver.(X8-M Series A FRN 3)
- Changed to detect pulling out of Ethernet connector in Socket MSG while waiting for timeout.(X8-M Series A FRN 3)
- Corrected Time Toggle Bits, SR2.31 clearing.(X8-M Series A FRN 3)
- Corrected operation of Apply All Parameters in Change Channel Configuration MSG instruction.(X8-M Series A FRN 3)
- Corrected the error check for Virtual Expansion I/O modules.(X8-M Series A FRN 3)
- Configuration download between CPU and Expansion I/O modules.(X8-M Series A FRN 3)
|
