CUSTOMER

Data room

Details
XGPC Ver 1.2.0.7 [EN]
Date : 2013.08.06Hit : 5754

Refer to the below.
 http://rsautomation.co.kr/bbs/data/oldfile/userfiles/file/XGPC_v1.2_ENG_Build2013-07-04.exe

XGPC v1.2 New Feature

This section provides information that has been added to the new release of XGPC. This includes the following:

  • Support the X8-M Series A FRN3.
  • Support the Socket Message Command in MSG instruction.
  • Support the Change Channel Configuration Command in MSG instruction.
  • Add monitoring resiger in system register(SR2). - SR2.25 : Number of pending ASCII instructions for COM0
    - SR2.26 : Number of pending ASCII instructions for COM1
    - SR2.27 : Number of pending ASCII instructions for USB
  • Add control register in sytem register(SR2). - SR2.1.5 : Added I/O Forces Enabled feature.
    - SR2.2.10 : Math Reg. Selection for L in DIV Instruction.
    - SR2.2.15 : Prevent clearing User Program after Hard Fault.
  • AHS instruction works for the following drivers - Xnet Slave
    - Xnet Master
    - Modbus RTU Slave
    - Modbus RTU Master
    - DF1-FD
    - NX-Alpha Master
    - NX-Plus Master
  • Added an option for Virtual Expansion I/O Module.

This section provides information on issues that have been resolved with the latest release of XGPC. This includes the following:

  • Corrected BCC and CRC calculation in Inline Indirect Address Translation feature while Inline Indirect Address is used before the BCC and CRC tags
  • Corrected MSG instruction for CIP Generic messaging. If the message is inserted by OLE in RUN mode, the message may be triggered continuously while the rung state is true.
  • Corrected the received number of characters for ASCII driver
  • Corrected Data Table Number for Diagnostic Counter - The Table Number 3 was not configured for Xnet over IP, Modbus TCP, and EtherNet/IP
  • Corrected ASCII Inline Indirect Address Translation feature for AEX instruction
  • On Modbus/TCP Server, Unit Identifier 0 may be used for Broadcast over remote serial network. So, the reply is not generated. In the earlier version of FW,
    the Modbus/TCP Server responded with Modbus TCP header only (with no Modbus packet)
  • On NX-Plus Master, removed the codes related to the broadcast. This protocol does not support broadcast. However, node 0 was implemented as if it is the broadcast address


Prev X8 PLC - Firmware Ver3.00
Next V-SFT-5 Plus(5.4.30.0)
go top