XGPC v1.8 New Feature
This section provides information that has been added to the new release of XGPC. This includes the following:
- Support the X8-M Series A FRN8.
- Added Extended PTO function
- Accel/Decel in PTO
- Limit Siwtch for PTO/Jog
- Homing
- Added new PTO error codes.
- Added indirect addressing for EGR and EGF instruction.
- Supported a Long data table for EGR and EGF instruction.
- Added indirect addressing for Timer, Counter, Control data table.
- Enhanced awareness of the available input in the Properties window.
(White background: input and changeable, LightGray background: read-only)
- Enhanced an IP address input.
- Enhanced a memory information in controller properties.
- Enhanced error and warning pane.
- Added a warning information for duplicate operand of OUT instruction.
- Added a counter number for searched items.
- Added a rung number in "END" Rung.
- Added a description of error code for each serial driver
- Added EB2RJ and RJ2EB in I/O module.
This section provides information on issues that have been resolved with the latest release of XGPC. This includes the following:
- Fixed the detection routine of duplicated output and output direction pins for PTO.
- fixed Error Code for NX-Plus Master Link Layer driver
- Fixed 76h Fault("Maximum IO number exceed").
- Fixed a wrong error("Error: The controller is not in Program mode.") in Firmware update mode.
- Fixed the operation of COM0/COM1/USB LED for serial drivers
- Fixed a wrong Symbol display.
- Fixed a incorrect disaply when you open PTO and Y0 data tables at the same time.
|